排灌机械工程学报

作者：RUAN Xiaofeng, ZOU Jialin, CHEN Zhengwen,XUE Shengxiong, LONG Xinping*

单位：1. Hubei Key Laboratory of Water Jet Theory and New Technology, Wuhan University, Wuhan, Hubei 430072, China; 2. Hefei General Machinery Research Institute, Hefei, Anhui 230071, China

关键词：abrasive water jet,Fourier analysis,roughness,carbon fiber reinforced plastic

To investigate the influence of operation parameters of abrasive water jet on surface roughness of carbon fiber reinforced plastic(CFRP), experimental studies have been conducted. The three-dimensional landscape of cutting front was reconstructed according to the measured data by μscan laser confocal microscopy. Fourier spectral analysis was also adopted to study surface structure in detail. It is found that the morphology of cutting front is similar to that of other materials. In the smooth cutting zone, the fluctuation of amplitudes of surface profile was gentler, compared with that in the rough cutting zone. The lower part of the rough cutting zone was characterized by the periodical appearance of peaks and valleys. The roughness of surface increased with the increase of depth. While in the smooth cutting zone and part of rough cutting zone, roughness increased with the increase of traverse speed. As for the thickness of samples, in the smooth cutting zone, the roughness increased with the increase of depth. The dominant harmonic component in the surface profile was concentrated in a narrow range from 0 to 10 Hz, and the relatively higher density of frequency from 10 to 50 Hz was shown in the rough cutting zone, which was caused by the interaction between perpendicular abrasive water jet and reflect jet.

来源：2019年第10期

《排灌机械工程学报》期刊编辑部

查看排灌机械工程学报杂志2019年第10期